Vook DVR Manuel d'utilisateur télécharger pdf (Page 11)

CONNECTION AND SETUP

2-2 To install on the second bracket

Connect the power connector and

data bus connector to the HDD.

When connecting the power

cable, make sure the cable is

passed through the power cable

of DVD writer. This is to prevent

the HDD power cable from

interfering with the fan spinning.

Align the screw holes of the

bracket with the HDD’s screw

holes. Make sure the PCB side of

the HDD is facing up. Then,

fasten the HDD to the bracket.

Note: For DVD writer installation, please refer to “APPENDIX 7 DVD WRITER

INSTALLATION” at page 56.

Step3: Close the upper cover of the DVR, and fasten all the screws you loosened in

Step1.

 For 4CH Model

Step1: Loose the screws on the upper cover and remove it from the DVR. Find the two

HDD brackets located on the DVR base.

Step2: Get a compatible HDD, and connect it to the power connector and data bus

connector.

Step3: Make sure the PCB side is facing up, and place the HDD between the HDD

brackets on the DVR base as shown below.

Make sure the other side of the HDD is contacted with the DVR base for

heat conduction.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Pas de commentaire

Vook DVR Manuel d'utilisateur Page 11